The AC voltage detector is used to indicate the presence or absence of line voltage. This is useful, for example to tell when the UPS is running on battery power.

The AC Voltage Detector indicates an ALARM/NORMAL condition in software and also via an LED mounted on the sensor. Voltage detectors can detect the presence or the absence of line voltage. It is designed for use worldwide. There is an SNMP interface for getting the alarm/normal status. SNMP traps are sent when critical conditions occur. SNMP polling via 'get' is available to retrieve existing status and configuration parameters. The Web browser interface is also available to display the status and configuration parameters.

When an alarm condition is activated the description and location of the fault can be sent via email, page or traps.

 

 Measurement range - Detects voltage at 50V AC to 250 VAC
 LED indicator on sensor shows if voltage present
 Measurement Indication - Alarm or Normal
 Communications cable - RJ45 jack to sensor using UTP Cat 5 wire
 Sensor type - open/closed contact switch
 Power source: powered by the sensorProbe. No additional power needed
 sensorProbe auto-detects the presence of the voltage sensor
 Measurement rate - multiple readings every second
 Up to 2 voltage detector per sensorProbe2, up to 8 on the sensorProbe8
 Full autoSense including disconnect alarm